Vivitek D5500 Manuel d'utilisateur télécharger pdf (Page 32)

– 25 –

PROJECTING AN IMAGE (BASIC OPERATION)

Turning on the Projector

Once the projector is correctly located and the power cable and other connections are in place, it is

important that the projector is powered on correctly in order to avoid damage to components and un-

necessary wear and tear. Refer to the following guide to power on the projector.

Connect the power cable (A). Press

the main power switch to the on ( I )

position as shown (B). All four LEDs

light orange, then the Lamp1 and 2

LEDs turn off and the Warning LED

lights green.

Press the POWER button once (see

OSD Controls and Status LEDs on

page 6). The Power LED flashes

green and the internal cooling fan

starts.

After approximately 10 seconds, the

Lamp1 and Lamp2 LEDs light green

and the Power LED flashes more rap-

idly.

Once the power LED is lit a solid

green, the projector is ready for use.

Note:

If any of the LEDs remain flashing or blink there may be a problem with the startup. Please refer to the

Troubleshooting section on page 87.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 112 113

Pas de commentaire

Vivitek D5500 Manuel d'utilisateur Page 32