Vivitek D512-3D Spécifications télécharger pdf (Page 43)

—

’

– 36 –

AINTENANCE AND

ECURITY

Replacing the Projection Lamp

The projection lamp should be replaced when it burns out. It should only be replaced with a certified

replacement part, which you can order from your local dealer.

Important:

a. The projection lamp used in this product contains a small amount of mercury.

b. Do not dispose this product with general household waste.

c. Disposal of this product must be carried out in accordance with the regulations of your local

authority.

Warning:

Be sure to turn off and unplug the projector at least 30 minutes before replacing the lamp. Failure to

do so could result in a severe burn.

Caution:

In rare cases the lamp bulb may burn out during normal operation and cause glass dust or shards

to be discharged outward from the rear exhaust vent.

Do not inhale or do not touch glass dust or shards. Doing so could result in injury.

Always keep your face away from the exhaust vent so that you do not suffer from the gas and bro-

ken shards of the lamp.

！

IF A LAMP EXPLODES

If a lamp explodes, the gas and broken shards may scatter inside the projector and they may come

out of the exhaust vent. The gas contains toxic mercury.

Open windows and doors for ventilation.

If you inhale the gas or the shards of the broken lamp enter your eyes or mouth, consult the doctor

immediately.

Loosen the captive screw on

the lamp compartment cover.

Remove the lamp compart-

ment cover.

Downloaded From projector-manual.com Vivitek Manuals

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 60 61

Pas de commentaire

Vivitek D512-3D Spécifications Page 43