Vivitek D512-3D Spécifications télécharger pdf (Page 44)

–

’

Remove the three screws

from the lamp module.

Lift the module handle up.

Disconnect the lamp connec-

tor.

Pull firmly on the module

handle to remove the lamp

module.

Reverse steps 1 to 6 to install

the new lamp module.

While installing, align the

lamp module with the

connector and ensure it is

level to avoid damage.

Note: The lamp module

must sit securely in place and

the lamp connector must be

connected properly before

tightening the screws.

Warning:

Lamp Connector must be installed flush with the connector base as shown in the image below.

A gap between the Lamp Connector and the connector base will cause damage to the projector.

The following images illustrate correct and incorrect Lamp Connector installations.

– 37 –

Downloaded From projector-manual.com Vivitek Manuals

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 60 61

Pas de commentaire

Vivitek D512-3D Spécifications Page 44